Playing time is not the whole turn

Timing only the interval between the first and last falling stick misses much of a booth's work. Explaining the rules, getting the player ready, recording the score and resetting for the next turn also take time. This article offers a planning method for a Catch Stick activity. Its example figures are not FUNTECHH device specifications or capacity claims.

Measure a complete cycle on site

During a trial, measure from inviting one player to the moment the station is ready to invite the next. Observe several consecutive turns with the actual operator, briefing and workflow. Record each start, finish and reason for delay, such as a question about the rules or score recording. Names and contact numbers are unnecessary for this measurement.

Record active playing time separately, but calculate throughput from the full cycle. Do not discard long turns: they may reflect the real experience. Keep the observed range and average alongside the number of turns sampled. This small dataset estimates that particular operation; it does not guarantee performance at every event.

A hypothetical capacity calculation

Suppose your trial shows an average complete cycle of 90 seconds. Dividing 3,600 seconds by 90 gives a calculated ceiling of 40 turns per hour, only with continuous operation and no interruptions. If your hypothetical plan reserves ten minutes of the hour for pauses, 3,000 divided by 90 gives approximately 33 complete turns. That pause allowance is an example assumption, not a maintenance instruction or a device duty cycle.

If six people are waiting ahead of a new arrival and none of their turns has started, the same assumption suggests about nine minutes until the newcomer starts. Add the remaining time of any game already in progress. Variable turn lengths and interruptions change this estimate. Display when it was last updated and avoid promising an exact minute.

Reduce waiting without rushing the player

HSE guidance says queues must not obstruct emergency access and people need a safe way to leave a queue. Apply these general principles to the venue's own layout and requirements.

Our operational suggestion is to explain the basic rules before a player's turn and keep optional activities, such as souvenir photos, outside the core cycle. Do not remove player preparation time or manufacturer-required steps just to shorten a queue. The number of turns you offer should fit observed throughput and the event's actual conditions.

When should new queue entries stop?

HSE recommends monitoring queuing areas and crowd distribution. If an operator also monitors the crowd, they need sufficient opportunity to do so. Counting completed games alone does not replace observing conditions around the booth.

Before opening, the venue lead and booth team should agree who decides to stop accepting new turns and how that decision is communicated. Update the stated wait when delays increase; do not promise a reopening time that is unknown. Determine waiting areas and permitted play boundaries from device instructions and the venue assessment. This article prescribes no fixed clearance or safe crowd capacity.

A short end-of-event review sheet

For each operating period, record completed turns, cycle lengths, downtime and the main cause of delay. Then choose one measurable change for the next session, such as clearer rule instructions. This lets you compare its effect with earlier observations without treating spectator counts as player counts.

The HSE sources here are general UK guidance, not a substitute for manufacturer instructions or local requirements. To plan with FUNTECHH Catch Stick, request a demonstration of the entire device cycle and documentation for the version available to order. Current website images are conceptual and cannot establish actual dimensions, capacity or device features.

Sources & further reading

Educational content prepared with AI assistance and the sources listed. Confirm the specifications of each model with its manufacturer.

Discover Catch Stick